Oops! It happens... Sometimes we drop our airbrush guns and the piece that holds the color cartridges gets bent, resulting in the cartridges not fitting.
Rather than buy a new airbrush gun, pick up a replacement part and take care of it yourself.
You'll need a T-7 Screw Driver (not included) for the 3 screws, and you'll need a blow dryer to heat up the locktite used at assembly.
1. Unscrew end cap from airbrush gun.
2. Remove little o-ring on the post you unscrewed the end cap from and set in a secure place.
3. Use blow dryer on "hot" for 45 secons on the gun to warm the screws. They are glued in, so this warms the glue; otherwise they will not come out.
4. Unscrew all 3 screw and set aside.
5. Remove and Replace Housing piece.
6. Re-assemble. Don't forget the little o-ring.
Included:
(1) Airbrush Cartridge Housing Replacement